The short version
Problem: A slab leak is a pipe leaking under the concrete slab; a plumbing leak is a pipe, fixture, or toilet leaking above it.
What to do: The meter test and the pattern — where the water is, what is warm, what is wet — tell them apart.
When to call: Call for detection when the meter moves with every tap off, or when the signs point under the slab.
The two kinds of leak
A slab leak is a pipe leaking under the concrete slab, where the water goes into the soil and comes up through the floor. A plumbing leak is a pipe, fixture, or toilet leaking above the slab — in a wall, under a sink, at a toilet base, or at a water heater. The two are different jobs, and the repair for one does not fix the other.
The difference matters because the search is different. A plumbing leak is found by looking at the fixture, the wall, or the appliance. A slab leak is found by listening through the floor, because the pipe is under the slab and cannot be seen. The meter test is the check that separates them.
The meter test
Turn off every tap, toilet, washing machine, ice maker and irrigation system, then watch the water meter. If the dial keeps moving, water is going somewhere it should not, and the leak is on your side of the meter. If the meter holds still, the leak is not on the supply side — and the investigation turns to the drain side, or to a running toilet or dripping tap.
The test takes a few minutes, and it is the most useful test a homeowner can do. It does not need equipment, it does not need access to the slab, and it answers the question directly: is water going somewhere it should not? A meter that moves is a leak; a meter that holds still is the soil.
Where the water is
Where the water shows up is the second clue. A wet floor in the middle of a room, with no fixture above it, points under the slab. A wet wall, a wet ceiling, or water under a sink points to a fixture or a pipe in the wall. A damp patch at the base of a toilet points to the toilet. A wet floor beside a water heater points to the heater. The water shows up near the leak, and the leak is usually near the water.
The pattern matters too. A slab leak is usually one damp patch, in one place, that comes back after mopping. A plumbing leak is usually water that comes and goes with use — when the toilet is flushed, when the shower runs, when the washing machine fills. The timing follows the fixture.
What is warm, what is wet
A warm floor points to a hot water line under the slab. A warm wall points to a hot water pipe in the wall. A warm floor and a cold wall point under the slab; a warm wall and a cool floor point to the wall. The floor is the place to look first — walk it barefoot, and mark where it is warm.
The sound helps too. A hiss or a rush heard through the floor, when every tap is off, points under the slab. A hiss or a rush heard in a wall, or at a fixture, points to the wall. The sound is loudest near the leak, and the operator follows it.
What the detection report says
Slab leak detection is a leak investigation on a home that shows signs of a leak under the slab: meter and pressure tests to confirm whether a pipe is leaking, acoustic listening to locate it, and a reading of the signs against the pattern of the house. The report records the meter readings, the pressure test results, the leak location if there is one, and the pattern of the symptoms — and it states, plainly, whether the evidence points to a slab leak, to a plumbing leak above the slab, or to something else.
The report is the document the repair decision is made from. It states what was found and where, and the repair — by any crew, at any time — starts from it. The homeowner keeps it, and the claim, if there is one, is built from it.
Related: Low water pressure · Water Line Leak Detection · slab leak help in McKinney
Related guides
Signs of a Slab Leak in McKinney
A slab leak hides under the floor, so the signs show up around it: a warm tile, a damp patch, a bill that jumped. Here are the signs, and the meter test that confirms them.
How Slab Leak Detection Works
Detection finds the leak before any digging starts: meter, pressure, listening, location. Here is each step, and what it tells you.
Slab Leak or Foundation Problem?
A crack can mean a leak or the clay moving. This guide explains how to tell them apart — by pattern, by meter, and by timing — before any work is planned.
Frequently asked questions
Questions people ask about this topic, answered plainly.
By the meter and the pattern. Turn off every tap and appliance, then watch the water meter — if it keeps moving, water is going somewhere it should not. A wet floor in the middle of a room with no fixture above it points under the slab; a wet wall or water under a sink points to a fixture or a pipe in the wall.
Yes. A toilet that runs can waste a lot of water and look like a leak, and a toilet that leaks at the base can wet the floor around it. Check every toilet first — a running toilet is the most common cause of a bill that jumped, and it is the simplest to fix.
The water goes into the soil first, and it may take weeks to reach the floor — or it may never reach the floor at all, if the soil absorbs it. A meter that moves with every tap off is a leak, even without a wet floor. Call for detection.
Yes, and it is more common than people think. A home can have a leak under the slab and a leak at a fixture, and the meter test finds the total, not the parts. The detection report separates them — the meter, the pressure tests, and the listening together say which it is.
Yes, because the pipe is under the slab and cannot be seen. A plumbing leak is found by looking at the fixture, the wall, or the appliance. A slab leak is found by listening through the floor, with a microphone, a locator, and sometimes thermal imaging or tracer gas.
Fix the fixture if it is clearly the problem — a running toilet, a dripping tap, a leaking supply line under a sink. Then check the meter again. If the meter still moves with every tap off, the leak is somewhere else, and the detection visit comes next.
Still have questions?
Call Now to reach a local slab leak professional — describe the water and the rooms it reached.
Call now for slab leak help
Tap Call Now to reach a local slab leak professional. Tell them the signs — a warm floor, damp flooring, the sound of running water, or a bill that jumped — and where in the house they show up.
Hours: Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET
Before you call
- Shut off the main water supply if it is safe to do so.
- Move valuables, rugs and electronics off wet floors.
- Take photos of the damp floor, the water meter, and the rooms affected.
- Stay away from wet outlets, switches and light fixtures.
- Note when the signs started, and whether the water meter moves when every tap is off.